10' Wall Canopy Hood, Fan, Direct Fired Heated Makeup Air Unit System

This powerful package includes a handsome Hood, an efficient Exhaust fan and a hefty Heated Make Up Air Unit.  And did someone say "free roof curbs"?

10' long exhaust-only wall canopy hood with front perforated supply plenum with built-in 3" back standoff.

  • 430 SS Where Exposed
  • 54" depth provides better capture and containment of cooking vapors at lower airflow volumes.
  • 600 degree hood rating - allows use with medium to heavy duty cooking equipment providing ultimate flexibility.
  • 16" tall x 20" wide Kleen-Gard Stainless Steel Baffle Filter with Handles and Bottom Hanging Hook, UL Classified
  • Incandescent Light Fixture-High Temp Assembly, Includes Clear Thermal and Shock Resistant Globe (L55 Fixture), Bulbs By Others
  • EXHAUST RISER - Factory installed 16" Diameter
  • SUPPLY RISER - 12"x 24" Supply Riser with Volume Dampers
  • 1/2 Pint Grease Cup New Style, Flanged Slotted

High Speed Direct Drive Centrifugal Upblast Exhaust Fan with speed control (single phase only), disconnect switch and 15-3/4" wheel.

  • Exhaust Fan handles 2250 CFM @ -0.750" wc ESP, Fan runs at 1302 RPM
  • Exhaust Motor: 0.750 HP, 1 Phase 115 V, 60Hz, 13.0 FLA, ODP (Open Drip Proof)
  • Grease Cup for kitchen-duty centrifugal exhaust fans, Box Dimensions 15-3/4 L X 5-1/16 W X 3-3/4 H (18 GA.) (Includes Down Spout)
  • Curb CRB23X20E On Fan # 1 Flat Curb
  • Hinged Base for Curb. Standard Hinge attached to curb. Used on Fans with wheels 20 inches or smaller. 12 GA Galvanized
  • Vented Base for Curb

Direct Gas Fired Heated Make Up Air Unit with 10" Blower.

  • Supply Fan handles 1800 CFM @ 0.500" wc ESP, Fan runs at 983 RPM
  • Heater supplies 110484 BTUs. 55°F Temperature Rise. [Fuel: Natural Gas]
  • Supply Motor: 1.000 HP, 1 Phase 115 V, 60Hz, 14.0 FLA, ODP (Open Drip Proof)
  • Down Discharge - Air Flow Right -> Left
  • Sloped Filtered Intake for Size #1 Modular Heater. 21.813" Wide x 44.375" Long x 23.375" High. Includes 2" MV EZ Kleen Metal Mesh Filters
  • RTC Solutions • 40-90°F Discharge Temp Control
  • Gas Manifold for DF1 GM - BTU 0 - 550001 - 7 in. w.c. - 14 in. w.c., No Insurance Requirement (ANSI), BV250-66
  • Motorized Back Draft Damper 16" X 18" for Size 1 Standard & Modular Direct Fired Heaters w/Extended Shaft, Standard Galvanized Construction, 3/4" Rear Flange, LF120S Actuator Included
  • Low Fire Start. Allows the burner circuit to energize when the modulation control is in a low fire position
  • Gas Pressure Gauge, 0-35", 2.5" Diameter, 1/4" Thread Size
  • Gas Pressure Gauge, -5 to +15 Inches Wc., 2.5" Diameter, 1/4" Thread Size
  • Curb CRB21X71X20INS Insulated On Fan # 2 Flat Curb